IEC 61784-1-2019 pdf free.Industrial communication networks – Profiles – Part 1:Fieldbus profiles.
This part of IEC 61784 defines a set of protocol specific communication profiles basedprimarily on the IEC 61158 series,to be used in the design of devices involved incommunications in factory manufacturing and process control.
Each profile selects specifications for the communications protocol stack at a device. Itcontains a minimal set of required services at the application layer and specification ofoptions in intermediate layers defined through references. lf no application layer is included,then a minimal set of required services at the Data-link layer is specified. The appropriatereferences to the protocol specific types are given in each communication profile family orassociated profiles.
NOTE All profiles are based on standards or draft standards or International Standards published by the lEC orfrom standards or International Standards established by other standards bodies or open standards processes.The structure of communication profile families is specified in Figure 1.
Each profile selects an appropriate consistent and compatible subset of services andprotocols from the total available set that is defined and modelled in lEC 61158.For theselected subset of services and protocols，the profile also describes any possible ornecessary constraints in parameter values.
Table 1 shows the communication profile families that are defined in this standard.
The following documents are referred to in the text in such a way that some or all of theircontent constitutes requirements of this document. For dated references，only the editioncited applies.For undated references, the latest edition of the referenced document (includingany amendments) applies.
NOTE All parts of the IEC 61158 series, as well as lEC 61784-1 and IEC 61784-2 are maintained simultaneously.Cross-references to these documents within the text therefore refer to the editions as dated in this list of normativereferences.
IEC 60079-11，Explosive atmospheres – Part 11: Equipment protection by intrinsic safety “i”
IEC 60079-25，Explosive atmospheres – Part 25: Intrinsically safe electrical systems
IEC 61010 (all parts)，Safety requirements for electrical equipment for measurement, controland laboratory use
IEC 61131-2,Programmable controllers – Part 2:Equipment requirements and testsIEC 61158(all parts), Industrial communication networks – Fieldbus specifications.
For the purposes of this profile, all abbreviations and symbols defined in the IEC 61158 seriesapply. The following abbreviations, found within the lEC 61158 series, are repeated here foruse by those who wish to understand the general structure of this International Standardwithout referring to the lEC61158 series.IEC 61784-1 pdf download.