BS EN ISO 10582:2012 pdf free.Resilient floor coverings – Heterogeneous poly(viny| chloride) floor coverings一 Specification.
BS EN ISO 10582 specifies the characteristics of non-cushioned, heterogeneous floor coverings, based on poly(vinyl chloride) (PVC), supplied in either tile or roll form. Products may contain a transparent, non-PVC factory finish.
To encourage the consumer to make an informed choice, this International Standard includes a classification system (see ISO 10874) based on the intensity of use, which shows where these floor coverings give satisfactory service. It also specifies requirements for marking.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1 05-B02: 1994, Textiles — Tests lr colour fastness — Part B02: Colour fastness to artificial light: Xenon arc fading lamp test
ISO 1 05-B02: 1994, Textiles — Tests for colour fastness — Part 802: Colour fastness to artificial light: Xenon arc fading lamp test. Amendment 1:1998
ISOITR 4918, Textile floor coverings — Determination of wear — Castor chair test
I SO 10874. Resilient, textile and laminate floor coverings — Classification
ISO 23996, Resilient floor coverings — Determination of density
ISO 23997, Resilient floor coverings — Determination of mass per unit area
ISO 23999. Resilient floor coverings — Determination of dimensional stability and curling after exposure to heat
ISO 24340, Resilient floor coverings — Determination of thickness of layers
ISO 24341, Resilient and textile floor coverings — Determination of length, width and straightness of sheet
ISO 24342, Resilient arid textile floor-coverings — Determination of side length, edge straightness and squareness of tiles
ISO 24343-1, Resilient and laminate floor coverings — Determination of indentation and residual indentation — Part 1: Residual indentation
3 Terms and definitions
For the purposes of this document, the fllowing terms and definitions apply.
3.1 heterogeneous floor covering
floor covering consisting of a wear layer and other layer(s) which differ in composition and/or design and can
contain a reinforcement
3.2 poly(vinyl chloride) floor covering
floor covering with surface layer(s) which are produced using poly(vinyl chloride) as the binder
3.3 wear layer
layer of the floor covering directly exposed to wear
3.4 factory finish
transparent coating applied during the manufacture, usually not thicker than 0,03 mm
3.5 binder content
that portion of the flooring composition, consisting of poly(vinyl chloride) (PVC) resin, plasticizers and stabilizers
NOTE Binder content is expressed as a percentage mass fraction of the total composition.
4 Requirements
4.1 ldentification requirements
Products described in this International Standard shall be identified by wear-layer binder content by mass as shown in Table 1.BS EN ISO 10582 pdf download.