ISO 11200-2014 pdf free.Acoustics — Noise emitted by machinery and equipment —  Guidelines for the use of basic standards for the determination of emission sound pressure levels at a  work station and at other specified positions.
ISO 11200 is the frame standard introducing the basic group, ISO 11201, ISO 11202, ISO 11203, ISO 11204 and ISO 11205, on the determination of emission sound pressure levels at work stations and other specified positions. It gives guidance for:
— facilitating the writing of noise test codes;
— providing physical explanations of this noise emission quantity compared to other noise quantities (see 41 to 43);
— comparing the different measurement methods offered by the group (see Table 1)
— facilitating the choice of the most appropriate method(s) in typical practical situations (Clause 6).
This International Standard is largely based on flow charts and tables. Case studies are described.
The guidance given applies to airborne sound only. It is for use in noise testing, in general, and in the preparation of noise test codes, in particular.
A standardized noise test code is intended to select standards from the ISO 11201, ISO 11202, ISO 11203, ISO 11204 and ISO 11205 group, which are the most appropriate to the machinery family it covers, and which give detailed requirements on mounting and operating conditions for the particular family, as well as the location of the work station(s) and other specified positions as prescribed in these International Standards.
The data so obtained can be used for the declaration and verification of emission sound pressure levels, e.g. as specified in ISO 4871.131
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 3741, Acoustics — Determination of sound power levels and sound energy levels of noise sources using sound pressure — Precision methods for reverberation test rooms
ISO 3743-1, Acoustics — Determination of sound power levels and sound energy levels of noise sources using sound pressure — Engineering methods for small movable sources in reverberant fields — Part 1:
Comparison method for a hard-walled test room
ISO 3743-2, Acoustics — Determination of sound power levels of noise sources using sound pressure — Engineering methods for small, movable sources in reverberant fields — Part 2: Methods for special reverberation test rooms
ISO 3744, Acoustics — Determination of sound power levels and sound energy levels of noise sources using sound pressure — Engineering methods for an essentially free field over a reflecting plane.ISO 11200 pdf free download.