ISO 11469-2016 pdf free.Plastics – Generic identification and marking of plastics products.
ISO 11469 specifies a system of uniform marking of products that have been fabricated from plastics materials. Provision for the process or processes to be used for marking is outside the scope of this international Standard.
NOTE 1 Precise details of the marking, e.g. the minimum size of the item to be marked, the size of the lettering, the appropriate location of the marking, are subject to agreement between the manufacturer and the user,
The marking system is intended to help identify plastics products for subsequent decisions concerning handling, waste recovery or disposal.
Generic identification of the plastics is provided by the symbols and abbreviated terms given in
ISO 1043-1. ISO 1043-2, ISO 1043-3 and ISO 1043-4.
NOTE 2 If more detailed information for material identification is needed, additional marking of plastics products can be applied as defined in the appropriate product standard.
This International Standard is not intended to supplant, replace or in any way interfere with the requirements for labelling specified in product standards or legislation.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 472, Plastics — Vocabulary
ISO 1043-1, Plastics — Symbols and abbreviated terms Part 1: Basic polymers and their special characteristics
ISO 10 43-2, Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials
ISO 1043-3, Plastics — Symbols and abbreviated terms — Part 3: Plasticizers
ISO 1043-4, Plastics — Symbols and abbreviated terms — Part 4: Flame retardants
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 472 and the following apply.
3.1 abbreviated term term resulting from the omission of any part of a term while designating the same concept
[ISOURCE: ISO 1043-1:2011,3.1]
3.2 plastics products
articles or stocks shapes of plastic materials for any type of application.ISO 11469 pdf download.