ISO 3865-2020 pdf free.Rubber, vulcanized or thermoplastic一Methods of test for staining in contact with organic material.
This document specifies three methods for estimating the staining of organic finishes (subsequently referred to as “organic material’) by vulcanized or thermoplastic rubber, as defined in Clause 3:
— method A: contact staining and migration staining;
— method B: extraction staining;
— method C: penetration staining;
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 105, AOl, Textiles — Tests for colourfastness — Part AOl: General principles of testing
ISO 105, A02, Textiles — Tests for colourfastness — Part A02: Grey scale for assessing change in colour
ISO 105, BO 1, Textiles — Te sts for colourfastness — Part BOl: Colourfastness to hqht: Daylight
ISO 188, Rubber, vulcanized or thermoplastic — Accelerated ageing and heat resistance tests
ISO 1382, Rubber— Vocabulary
ISO 2393, Rubber test mixes — Preparation, mixing and vulcanization — Equipment and procedures
ISO 4892-1, Plastics — Methods of exposure to laboratory light sources — Part I: General guidance
ISO 4892-2, Plastics — Methods of exposure to laboratory light sources — Part 2: Xenon-arc lamps
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 1382 and the following apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https://www.ia.org,fibp
— IEC Electropedia: available at http://www.electropedia.org/
3.1 contact staining
stain which occurs on the surface of the organic material directly in contact with the rubber
3.2 migration staining
stain which occurs on the surface of the organic material surrounding the contact area
3.3 extraction staining
stain which occurs on the surface of the organic material as a result of contact with a liquid containing leached out constituents of the rubber
3.4 penetration staining
stain which occurs on the surface of a veneer layer of an organic material which is bonded to the rubber surface
4 Principle
4.1 Method A — Determination of contact straining and migration staining
The rubber to be tested is placed in direct contact with the specified organic material and then exposed to heat and/or artificial light.
4.2 Method B — Determination of extraction staining
The rubber to be tested is subjected to a test liquid which afterwards contacts the organic material. This may be followed by irradiation of the organic material.
4.3 Method C — Determination of penetration staining
A light-coloured veneer or lacquer of specified material is applied to the rubber to be tested and then exposed to heat followed by artificial light.
4.4 Assessment of staining
The stain is assessed qualitatively by visual inspection or quantitatively by comparison with a grey scale or by using a reflectance spectrometer.
5 Apparatus
Use the following apparatus for the methods indicated.ISO 3865 pdf download.