ISO 4628-3-2016 pdf free.Paints and varnishes – Evaluation of degradation of coatings – Designation of quantity and size of defects, and of intensity of uniform changes in appearance – Part 3: Assessment of degree of rusting.
This part of Iso 4628 specifies a method for assessing the degree of rusting of coatings by comparison with pictorial standards.
The pictorial standards provided in this part of ISO 4628 show coated steel surfaces which have deteriorated to different degrees by a combination of rust broken through the coating and visible underrust.
NOTE 1 The pictorial standards have been selected from the European rust scale published by the European Confederation of Paint, Printing Ink and Artists’ Colours Manufacturers’ Associations (CEPE), Brussels. The correlation between the ISO scale and the “European rust scale’ is given in Annex B. Table B.1.
NOTE 2 The correlation between the ISO scale and the rating system ofASTM D 610 Is given In Annex B. Table B.2.
NOTE 3 The rust formation on uncoated steel surfaces Is designated In accordance with ISO 8501-1 (rust grades A, B, C, and D).
ISO 4628-1 defines the system used for designating the quantity and size of defects and the intensity of changes in appearance of coatings and outlines the general principles of the system This system is intended to be used, in particular, for defects caused by ageing and weathering, and for uniform changes such as colour changes, for example yellowing.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 4628-1:2016, Paints and varnishes — Evaluation of degradation of coatings — Designation of quantity and size of defects, and of intensity of uniform changes in appearance — Part 1: General introduction and designation system
ISO 13076, Paints and varnishes — Lighting and procedure for visual assessments of coatings
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
3.1 degree of rusting Ri rating characterizing the degree of rust formation (rust broken through and visible underrust) on a coating.
4 Assessment
Assess the degree of rusting (Ri) on a coating by means of the pictorial standards given in Figure 1 to Figure 5. The approximate areas rusted (rust broken through plus visible underrust) shown on these standards are as indicated in Table 1.
Procedures for assessing invisible underrust, if required, shall be agreed between the interested parties. Where different degrees of rusting occur in different parts of the area being assessed, indicate these degrees of rusting together with the part where each occurs.
Carry out the assessment under good illumination, as specified in ISO 13076.
If the average size of the rust spots on the test area differs considerably from those shown in the pictorial standards, an indication of their size may be given by reference to ISO 4628-1:2015, Table 2.ISO 4628-3 pdf free download.
ISO 4628-3-2016 pdf free
- Download here
-
-
- Attention:
- It is recommended to use winrar v3.10 or above to extract the information of this website.
- If this file cannot be downloaded, please contact the webmaster.
- In order to achieve the fastest download speed, please do not download multiple files at the same time. If you can't download for the moment, please try again later.
- The standards shared by this website are for learning only. If they are used for commercial purposes, please go to the official website to buy the authentic standards.
- Recommended Download