ISO/DIS 9242-2015 pdf free.Pliers and nippers – Construction worker’s pincers – Dimensions and test values.
ISO/DIS 9242 specifies the principal dimensions of construction worker’s pincers and the test values in order to verify their aptitude to function in conformity with ISO 5744. The general technical requirements are given in Iso 5743.
The construction worker’s pincers illustrated in this International Standard are only examples and are not intended to affect the manufacturers’ design.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 5743:2004, Pliers and flippers — General technical requirements
ISO 5744:2004, Pliers and flippers — Methods of test
3 Dimensions and test values
3.1 Construction workers pincers — Style A
Construction worker’s pincers, style A, shall be tested in accordance with ISO 5744.
After the load test, the permanent set s shall not exceed the value given in Table 2. If the distance L1 is not suitable for the load test, the following formula may be applied:
is the load which is not given in Table 2;
is the load given in Table 2;
is the distance from the centre of the joint rivet to the point of application of the load given in Table 2;
is the measured distance from the centre of the joint rivet to the point of application of the load.
The cutting force F1 and the diameter D of the test wire shall not exceed the values given in Table 2.
Pincers having a lever ratio differing from the values given in Table 2 may be checked for compliance using the following formula:
is the maximum cutting force which is not given in Table 2;
is the cutting force of medium hard test wire (see ISO 5744);
is the correction factor for medium hard test wire;
is the measured distance from the centre of the joint rivet to the point of application of the load;
is the measured distance from the centre of the joint rivet to the cutting edges.ISO/DIS 9242 pdf free download.